This MCP9600 is one of the best thermocouple chip available in the market, you can connect up to 8 of these boards on one I2C bus. This K-type thermocouple MCP9600 talks to master devices using I2C communication and it usages analog addressing, so on the board there is a potentiometer which you can use to change the I2C address. You can use this thermocouple to measure the temperature of a liquid, for example you can use it with a relay controller and turn on off a heater which heats up the water, so in this case you can use this thermocouple to measure the liquid temperature and heat it up at a fixed temperature. You could put the board far away from the high temperature and use the thermocouple to read the temperature. The long wire comes in real handy during installation. The length of thermocouple wire is around 44 inches (112 cm). The board is small in size and comes with mounting holes, which makes installation real easy. The thermocouple board comes with one I2C cable, one k-type thermocouple and the MCP9600 mini module. K type thermocouple MCP9600 Board Overview To Interface K-type thermocouple MCP9600 with Arduino you will need following hardware, all these parts can be found on ncd.io This K-type thermocouple uses the MCP9600 and may be used in high temperature application like temperature measurement of an oven, heating plates, boiler temperature measurement, grill temperature measurement and much more. In this article we will be using K-type thermocouple with a MCP9600. If you are looking for a high accuracy, wide range, high temperature, low temperature, low cost industrial grade thermocouple device then this article is for you. Thermocouples are one of the most interesting electronic components.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |